Abstract
During the past years,much work has been done to study the steam,liquid jet technology.However,the working steam in these work are mainly supersaturated steam and superheated steam,work on wet steam in steam-liquid jet technology has not been reported.In industrial application,wet steam with certain dryness is often used as low-pressure steam.Therefore,steam-liquid two-phase flow process is studied on a steam-liquid ejector with multi-nozzle structure by using wet steam as working steam.The pressure change in the ejector and the effect of steam pressure and cool water temperature on the evenness degree of steam and liquid phase mixture in the ejector are obtained.As can be seen from the results,steam dryness has little effect on the pressure distribution in the ejector.The pressure at the outlet of water nozzle and the inlet of cylindrical section of mixing chamber reaches the minimal value under a certain steam pressure,and the value of steam pressure is greater than the optimal steam pressure.Increasing steam pressure and cool water temperature are all helpful to the uniform mixing of steam and liquid phase in mixing chamber.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.