Abstract
Investigation on non-Newtonian fluid flow in microchannels is of both fundamental interest and practical significance. Flow characteristics of deionized water and the PAM solution over a wide range of Reynolds numbers in fused silica microtubes with diameters from 75 to 250μm, fused silica square microchannels with equivalent diameters of 75 and 100μm, and stainless steel microtubes with diameters from 120 to 300μm, were studied experimentally. The obtained mass flow rate and friction factor for deionized water in smooth fused silica microchannels were in good agreement with theoretical predictions for conventional-sized channels while the deviation for stainless steel microtubes was observed due to the roughness. Friction factors of the PAM solution were much higher than conventional theoretical predictions. Flow behaviors of deionized water and the PAM solution under hydrophobic condition are also studied experimentally. The mass flow rate increased in hydrophobic microchannels compared to untreated microchannels. The drag reduction in hydrophobic channels is greater for rough stainless steel microtubes than for smooth fused silica channels. The effect of surface wettability on the shear thinning PAM solution is also observed to be more evident than on the Newtonian deionized water.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
