Experimental investigation of nanosecond pulsed laser ablation of polycrystalline diamond composite

Abstract

A fundamental understanding of the laser ablation of polycrystalline diamond composite (PCD) at different laser energy intensities is indispensable for extending these findings to practical applications where, through appropriate parameter combinations, a substantial amount of material with minimal thermal damage should be removed. The objective of this study is to investigate experimentally the nanosecond ablation of polycrystalline diamond composite at different laser pulse energies and input energy densities. The research comprised two distinct categories of experiments: (1) single-point and (2) line experiments. In single-point tests, the number of the incidence pulses (N.P) was varied from 1 to 100 pulses with different pulse energies (Ep) ranging from 40 to 200 µJ. As the N.Ps increased, the ablation depth increased as well. No considerable enhancement in ablation depth was observed with the increase in pulse energies. For the line experiments, the results emphasized the differences in ablation depths by nearly a factor of 2, resulting in a corresponding change in laser input densities from 6.5 J/mm2 to 1.3 J/mm2. The ablation difference was pronounced as the number of repeats of the scanning path increased. The results emphasize that the ablation depth varies at the same pulse energy when the pulse overlap decreased from 100 % to lower percentages. Based on these results, a constant laser energy density with three different combinations of laser inputs—namely, scanning speed and average power—was selected to evaluate the ablation depth and quality. The results show that in moderate numbers of scan repeats (here 20, 30 & 40 times), it is advisable to adopt a minimum pulse energy when the same ablation depth is achieved compared to higher pulse energies. The ablation pile-up was also evaluated in these repeat ranges, indicating that higher pulse energies and repeats do not result in ablation improvement and cause excessive melt deposition.