Abstract
Understanding the local operating state and voltage loss distributions are of great importance to guide the performance improvement of proton exchange membrane fuel cells (PEMFCs). Especially when the active area is large, the uneven electrochemical reaction becomes more severe. However, the current research does not enable the simultaneous monitoring of the multiple operating states and decoupling of the voltage losses in the fuel cell. In this study, a method is established that can obtain the distribution of activation polarization, ohmic loss, and concentration polarization by analyzing the measured data of temperature, humidity, current density, and high-frequency resistance (HFR), which are obtained inside a 320 cm2 and 3 kW level fuel cell stack by using the multilayer printed circuit board (PCB) technology with designed isolation segments. The effects of humidity, operating temperature, and current density on the distributions of output voltage and voltage losses are discussed. Results show that the potential distribution on the surface of membrane exchange assembly (MEA) isn’t uniform in the large active area. The activation polarization gradually increases in the direction of coolant flow and the direction of the cathode flow and the ohmic loss and concentration polarization have opposite distribution characteristics. In addition, when the humidity rises to full humidity, the inhomogeneity of ohmic loss distribution becomes higher with three local increased areas of 20 mV and one decreased area of −20 mV. Higher temperatures can significantly reduce the flooding near the outlet of the active area. When the current density increases, the inhomogeneity of the ohmic loss distribution increases, and the concentration polarization near the cathode outlet of the active area become more severe.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call