Abstract
AbstractAccurate evaluation of the wind convection heat transfer coefficient (hw) for solar‐based systems is essential, especially for solar desalination systems. Thermal behavior and productivity of solar stills are highly affected by the external heat loss through the glass cover. This paper describes a new experimental approach to estimate the hw on the glass cover of the conventional single‐slope solar distiller (CSS). Indoor experiments have been conducted under steady‐state conditions for a wind speed between 0 and 3 m/s. The hw has been evaluated through an energy balance performed on the distiller's glass cover. The results showed that increasing the wind speed increases the hw (from 5.64 to 31.57 W/m2 K) and enhances the distillation rate (from 5.28 to 7.61 mL/min). A new relationship for the hw was proposed for the CSS and compared with the experimental data available in the literature. The comparison shows that the obtained results are close to the data from solar systems, with a deviation ranging from 27.4% to 37%. However, a significant deviation was obtained with earlier models derived from flat plates (from 29.5% to 59%).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.