Abstract
The solar heat collector with the impingement of jet lower plate (SAHJF) experimentally designed and operated with typical parameters obtained from theoretical analysis to contained the maximum efficiency of the performance of thermal transfer. Then it was developed by replacing the flat absorber by the corrugated absorber (SAHJC) to enhance the efficiency. The flow rate of mass was selected equal and more than the typical value and the intensities of the solar radiation were chosen equal and less than the typical value to investigate the effect of both on the thermal transfer efficiency for SAHJF and SAHJC. Since the system works with a short range of temperature, the temperatures recorded were sensitive and needed a large accuracy. Therefore, an analysis method was proposed and applied to the data to be sure that it reflects the variance of temperature with different operating parameters. The correlation of temperature difference between the outlet and the inlet air with different flow rate and different intensities of irradiation for SAHJF and SAHJC was presented and compared.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
