Abstract

The microscopic deformation behavior of Inconel 625 superalloy has been investigated by means of nanoindentation experiments and crystal plasticity finite element simulations. Based on the electron backscattered diffraction characterizations, the nanoindentation simulations were performed on grains with various orientations. The simulated load–displacement curves match well with those of experiment and the maximum difference in materials hardness between the experimental and the simulation result is about 6.86%, which is within the accuracy of the model. Moreover, surface Schmid factor (SSF) and interior Schmid factor (ISF) were proposed out and the scanning electron microscope and atomic force microscope characterizations were carried out. The results show that the pile-up tends to occur at the locations with a large SSF. Subsequently, the simulations of nanoindentation on [001]-, [011]-, and [111]-oriented grains were performed by the established model. It is revealed that the residual topography changes periodically when the indenter is fixed and the crystal only rotates around the Z-axis of the sample coordinate system. Combining with the analysis of the ISF, this periodicity of residual topography reflects the superimposed effect of the slip systems, and a large ISF promotes the in-plane displacement of the interior material which inhibiting the evolution of pile-up, while a small ISF leads to a high pile-up.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.