Abstract
This paper presents an experimental investigation and nonlinear finite element analysis (NLFEA), using the numerical analysis tool ANSYS©, carried out on the shear and diagonal cracking effect on the behaviour of reinforced-concrete (RC) beams made of normal strength concrete (NSC) and high-strength concrete (HSC), with and without transverse reinforcement. Beams were tested using four-point bending, by means of digital image correlation (DIC). In the experimental setup, the shear zone was digitised using a high-resolution camera to assess the deformation of concrete in the compression zone and to measure the diagonal crack widths. The results show that transverse reinforcement does efficiently control the diagonal crack width, increases the shear capacity of the beams, shifts the mode failure from shear to flexure, and significantly improves the ductility of beams in the ultimate state particularly when using HSC, given the better quality of the bond developed in the concrete with steel reinforcement. The values of ultimate shear strength obtained experimentally were compared to the corresponding empirical values available in the literature. Furthermore, detailed 3D finite element analysis (FEA) was used to predict the load–deflection response, the ultimate load, the cracking load, the ultimate deflection, the maximum diagonal crack widths and the cracks patterns in RC beams. The disparity in values between the numerical and experimental values is ranging from −11.08 to +0.6%, −2.02 to −0.52% and −13.27 to −1.01% for cracking load, ultimate load and ultimate mid-span deflection, respectively. While the ratio of the predicted to experimental maximum diagonal crack width for the beams ranged between 0.95 and 1.06. Also, a good agreement between the experimental and numerical crack patterns was achieved. Consequently, the FEA model is able to predict the shear response of RC beams with a good accuracy.
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call