Experimental and Modelling Investigations of Asphaltene Precipitation During Pressure Depletion and Gas Injection Operations

Abstract

Asphaltene precipitation problems manifest themselves in different stages of oil reservoirs production. Experimental and modeling investigations are, therefore, employed as promising tools to assist in predictions of asphaltene precipitation problems and selection of proper production facilities. This study concerns experimental and modeling investigations of asphaltene precipitation during natural production and gas injection operations for a heavy Iranian crude oil at reservoir conditions. First, with design and performance of high pressure–high temperature experiments, asphaltene precipitation behavior is comprehensively investigated; the effects of pressure and temperature are fully studied during pressure depletion tests and the role of injection gas composition on precipitation is described in gas injection experiments. In the next stage, the obtained experimental results are fed into a commercial simulator to develop the asphaltene precipitation model. The results for the pressure depletion experiments indicate that the maximum amount of asphaltene precipitation takes place at fluid bubble point pressure. Increase in the temperature, as seen, causes to reduce the amount of precipitation for the entire range of pressures. For gas injection experiments, the onset of precipitation for CO2, associated, and N2 gases takes place at around 0.20, 0.28, and 0.50 gas to mixture mole ratios, respectively. Carbon dioxide shows the highest asphaltene precipitation values and nitrogen has the lowest amounts for the whole range of gas mole fractions. Finally, the results for modeling indicate successful asphaltene precipitation predictions for both pressure depletion and gas injection processes.