Exosome-like genistein-loaded nanoparticles developed by thin-film hydration and 3D-printed Tesla microfluidic chip: A comparative study

Abstract

Exosomes are naturally derived information carriers that present interest as drug delivery systems. However, their vague cargo and isolation difficulties hinder their use in clinical practice. To overcome these limitations, we developed exosome-like nanoparticles, consisted of the main lipids of exosomes, using two distinct methods: thin-film hydration and 3D-printed microfluidics. Our novel microfluidic device, fabricated through digital light processing printing, demonstrated a favorable architecture to produce exosome-like nanoparticles. We compared these two techniques by analyzing the physicochemical characteristics (size, size distribution, and ζ-potential) of both unloaded and genistein-loaded exosome-like nanoparticles, using dynamic and electrophoretic light scattering. Our findings revealed that the presence of small lipophilic molecules, cholesterol and/or genistein, influenced the characteristics of the final formulations differently based on the development approach. Regardless of the initial differences of the formulations, all exosome-like nanoparticles, whether loaded with genistein or not, exhibited remarkable colloidal stability over time. Furthermore, an encapsulation efficiency of over 87% for genistein was achieved in all cases. Additionally, thermal analysis uncovered the presence of metastable phases within the membranes, which could impact the drug delivery efficiency. In summary, this study provides a comprehensive comparison between conventional and innovative methods for producing complex liposomal nanosystems, exemplified by exosome-like nanoparticles.