Exchangeable versus residual metals in naturally aged plastic litter.

Abstract

Metals may be associated with plastics as additives arising from manufacture or through acquisition from the environment, but these associations are often poorly defined or referred to synonymously when considering metal availability. In this study, samples of plastic litter (n = 22) have been collected from various environmental and industrial compartments of Lublin Province, Poland, and fractionated according to polymer type (polyethylene, polyethylene terephthalate, nylon, expanded polystyrene, polypropylene, and "mixed") before being micronised to < 2mm. Composites (n = 89) were subjected to two phases of a standardised and widely employed sequential extraction protocol (Bureau Communautaire de Reference; BCR) in order to define available (acid-soluble and exchangeable) and residual (soluble in boiling aqua regia) concentrations of Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, and Zn. For a given metal, total content, calculated by summing available and residual components, was highly variable, both between locations and amongst polymer categories, reflecting the heterogeneous distribution of a multitude of different additives. Overall, however, concentrations were greatest for Fe, with medians of several hundred to several thousand mg kg-1 amongst the different polymers, and lowest for Cd, Co, and Ni, where nearly all concentrations were below 10mgkg-1. Median percentage metal availabilities were greatest for expanded polystyrene and were above 25% for Mn and Zn and below 10% for Cr and Fe in all polymer types. These observations are largely, but not entirely, attributed to the relative contributions of metals acquired from the environment and metals present as additives and residues. Significantly, the approach employed allows direct comparisons of metal availability in plastics with metal availability in environmental solids in order to evaluate the overall impacts of plastics in metal risk assessments.