Abstract
This article presents an experimental study of the material extrusion process to examine the impact of less-analyzed factors on surface roughness, not including the commonly known layer height. The study also gives attention to the inner surfaces of printed samples. The design of experiments used a fractional factorial design with five two-level factors: bed temperature, fan percentage, printing speed, printing temperature, and wall thickness. Thus, the purpose of the design is screening. A two-dimensional contact profilometer was used to measure the surface roughness. Generally, the inner faces of the printed samples showed lower surface roughness. In addition, four analysis of variance showed that wall thickness (for Ra and Rz) and printing speed (for Ra) are significant for the outer and inner surfaces, respectively. As the wall thickness increased, the surface roughness decreased. Meanwhile, the lower the printing speed, the worse the surface quality on the inner faces.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
