Abstract
In the paper is presented an examination of the mechanical properties of the samples made of polymer materials Polylactic Acid (PLA) and Acrylonitrile Butadiene Styrene (ABS). Specimens of the first and second series, were made with 100 % PLA filling and 100 % ABS filling. The third series of specimens was made with 100 % filling from PLA material and 20 % filling from ABS material. The specimens were made according to ISO 527 – 2: 1993 and tested in a tensile test. Samples with the highest proportion of PLA material had the highest average maximum force value compared to samples made of 100 % ABS filling. Samples made with different filling ratios of PLA and ABS materials gave worse results than expected. The reasons for the poor expected result should be sought in the additional optimization of printing parameters, as well as a larger number of specimens with varying proportions of PLA and ABS materials.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call