Evolution of Yield Loci for Aluminum Alloy AA6016 and Deep Drawing Steel DC06 under the Influence of Non-Linear Strain Paths

Abstract

The application of modern materials plays an important role directly under the aspect of lightweight potential. To exploit these options effectively a numerical accurate reproduction of the material behavior is indispensable. Especially in the case of large deformations a directional and strain rate dependent hardening behavior can be observed. By disregarding this effect significant failure in the computed stress state can arise, which can conduct to a corruption of the spring-back forecast. Within this contribution a new test method for analyzing the evolution of subsequent yield loci under strain path changes for the aluminum alloy AA6016 and the deep drawing steel DC06 is presented. In the first stage of the experimental investigations, yield loci with linear strain paths were considered to characterize the material behavior for the initial condition. On further experiments with several stress states the strain path dependent hardening behavior of the material is determined. The non-linear strain paths are realized through uniaxial prestrained primary specimens with following extraction of secondary samples for following stress states, e.g. a modified ASTM simple shear test specimen. Subsequent yield loci are investigated and compared to the yield surfaces Hill48 and Barlat 2000 (Yld2000-2d) with an isotropic hardening behavior. With this study the evolution of the yield locus for prestrained specimens is evaluated. The research of the subsequent yield loci for strain path changes serves as basis for further scientific investigations with a view to assess different approaches of isotropic-kinematic hardening models in consideration of the analyzed steel and aluminum sheet metals.