Evolution of recrystallization texture in nickel-iron alloys: experiments and simulations

Abstract

ABSTRACT The present work is aimed at examining the effect of solid solution on the development of recrystallization microstructure and texture in FCC materials where SFE remains unchanged on alloying addition. To elucidate the mechanisms of texture formation during recrystallization, pure Ni and Ni-Fe (20 and 40 wt.% Fe) alloys were investigated. After recrystallization, pure Ni showed a cube and a non-uniform α-fibre texture, whereas the Ni-Fe alloys showed a texture characterised by the rotated cube component, brass recrystallization (BR) orientation, and a non-uniform α-fibre. Addition of Fe to pure Ni has led to some fine differences in the recrystallization texture that have been attributed to the role of highly heterogeneous deformed microstructure in the Ni-Fe system because of alloying. However, in all the cases Cu-oriented grains are prone to early recrystallization due to relatively more heterogeneously deformed regions, whereas deformed grains having orientation <110> || ND have shown slow recrystallization. In all cases, the entire stage of recrystallization is dominated by the formation of annealing twin (Σ3) boundary. The mobility of these twin boundaries plays an important role in the evolution of the recrystallization texture, which in turn, depends on its coherency, i.e. grain boundary plane (K1) of twin boundaries. The mechanism of evolution of recrystallization texture and the role of different deformation features during recrystallization is investigated. The cellular automata simulation technique was used to simulate the recrystallization behaviour of the alloys. The simulation results were used to discuss experimental observations.