Evidence from mineral assemblages for infiltration of pelitic schists by aqueous fluids during metamorphism

Abstract

Prograde mineral assemblages and compositions have been predicted for pelitic schist in the 10 component system Na2O−K2O−CaO−MnO−FeO−MgO−Al2O3−SiO2−CO2−H2O for three cases of prograde metamorphism and fluid-rock interaction: (1) increasing temperature (T) at constant pressure (P) and constant pore fluid volume (1%) without infiltration (no-infiltration case); (2) increasing T at constant P accompanied by sufficient fluid infiltration that fluid composition is at all times constant (large-flux case); and (3) increasing T at constantP accompanied by a timeintegrated fluid flux f 104 cm3 cm 2 (intermediate-flux case). Stable mineral assemblages and compositions were calculated by solving a system of non-linear equations that specify mass balance and chemical equilibrium between minerals and fluid. The model pelitic system includes quartz, muscovite, plagioclasc, chlorite, ankerite, siderite, biotite, garnet, staurolite, andalusite, kyanite, sillimanite, K-feldspar, and a coexisting, binary H2O−CO2 fluid. Specifically, prograde thermal metamorphism was modelled for Shaw's (1956) average low-grade pelite and for a moderate range of bulk rock compositions at P=3, 5, and 7 kb and initial fluids with Xco 2 o =0.02–0.40. The model predicts a carbonate-bearing mineral assemblage for average pelite under chlorite zone conditions composed of quartz, muscovite, albite, chlorite, ankerite, and siderite. The mineral assemblages predicted for the noinfiltration case are unlike those typically observed in regional metamorphic terranes. Simulations of metamorphism for the large-flux and intermediate-flux cases, however, reproduce the sequence of mineral assemblages observed in normal Barrovian regional metamorphic terranes. These results suggest that regional metamorphism of pelitic schists is typically associated with infiltration of significant quantities of aqueous fluid.