Abstract
In this article, innovative electrically conductive polymer nanocomposites based on poly(butylene terephthalate) (PBT) filled with carbon nanotubes (CNTs) at different concentrations, to be used in the automotive field, have been investigated. Field emission scanning electron microscopy (FESEM) analysis revealed how a good nanofiller dispersion was obtained, especially by using surface treated nanotubes and by processing these materials using a more restrictive screw configuration. Melt flow index measurements highlighted that the processability of these nanocomposites was reduced at elevated filler amounts, even if CNT surface treatment promoted a partial retention of the fluidity of the neat PBT. Thermal degradation stability was improved upon the addition of CNT, even at limited filler amounts. Differential scanning calorimetry measurements evidenced how the presence of CNT slightly increased both the crystallization temperature and the crystalline fraction of the materials. The additivation of CNTs promoted a stiffening effect at elevated CNT contents, associated to an evident embrittlement of the samples. Electrical resistivity measurements showed that the most interesting results (i.e. 2.6 × 101 Ω·cm) were obtained for nanocomposites with a total filler content of 3 wt%, processed using the more restrictive screw configuration. For these materials, it was possible to obtain a rapid surface heating through Joule effect at applied voltages of 12 V.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.