Abstract

Abstract The improvement in the recovery of light oil by high pressure air injection (HPAI) involves a combination of complex processes, each contributing to the overall recovery. One of these processes is the spontaneous ignition of the air-oil mixture with complete oxygen utilization. This process generates flue gases, which are in contact with the reservoir oil at the displacement front. An experimental study was carried out to investigate the mechanism and contribution of miscible displacement, by in situ generated flue gases, to the recovery of light oil in reservoirs undergoing HPAI. The flue gas displacements were carried out on recombined reservoir oil in a slim tube apparatus at a reservoir temperature of 116 º C and pressures ranging from 27.77 MPa (4,028 psi) to 46.06 MPa (6,680 psi). Results show that miscibility could not be achieved between the test oil and flue gases under the test conditions. Experiments conducted between 41.28 MPa (5,987 psi) and 45.04 MPa (6,532 psi), however, gave an indication of near-miscible displacement of the test oil. The flue gases displaced the oil in a forward contacting extraction process, resembling a combined vapourizing/condensing multi-contact gas drive mechanism. The relatively high recovery, high extraction of oil components, and the pattern of flow behind the displacement front, exhibited at high pressures, demonstrate that near-miscible displacement by in situ generated flue gases could significantly contribute to oil recovery in light oil reservoirs undergoing HPAI. Introduction Air injection into high pressure reservoirs is an emerging technology for the enhanced recovery of light oils. It is probably the best hope for improved recovery from the world's ever declining reserves of conventional oil and, in particular, the profitable enhanced recovery of the enormous quantities of residual oil trapped in depleted and mature waterflooded light oil reservoirs(1, 2). Air is the most inexpensive, available gas that can be used to accelerate oil recovery. Air injection is especially applicable in low porosity and low permeability reservoirs where water injectivity is extremely low(3). Apart from providing a better interfacial tension (IFT) response(4), air injectivity is about ten times that of water in terms of reservoir volume(5), making air injection more advantageous than water injection in deep, tight, high pressure reservoirs. A number of successful high pressure air injection projects in light oil reservoirs have been documented in the literature(5–11). Most of these projects have been operating for many years, attesting to their technical and economic success. The improvement in recovery of light oil by HPAI involves a combination of complex processes, each contributing to the overall recovery. These processes include: reservoir pressurization, oil swelling, immiscible gas displacement, and superextraction when operating above the critical point of water. In addition to this, spontaneous oil ignition with complete oxygen utilization(2, 12, 13) and near-miscibility/miscibility of the in situ generated flue gases with the reservoir oil(13) are possible and advantageous processes. Apart from reservoir pressurization, oil swelling, and immiscible gas displacement, the mechanism by which the other processes occur in the reservoir and their contribution to oil recovery have not been discussed in clear terms in the technical literature(14).

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call