Abstract
The treatment of early onset scoliosis (EOS) has seen significant advancements, particularly with the introduction of magnetically controlled growing rods (MCGR). However, a discrepancy between reported and actual rod lengthening during treatment has raised concerns. This retrospective study aims to investigate the disparity between reported and actual lengthening of MCGR and to identify factors contributing to the failure of the lengthening process. Radiographs of the whole spine taken immediately before and after surgery were used for measurements. Documented rod lengthening read from the external remote controller (ERC) was used for analysis. The distraction procedure was classified as failed when the quotient of the measured distraction of MCGR actuators on radiographs and the declared lengthening of the rods using the ERC device was less than 0.3. Analysis of fifty patients with idiopathic and neuromuscular scoliosis revealed a diminishing discrepancy between ERC-reported lengthening and radiographic measurements after the sixth distraction (p < 0.05), with noticeable failures occurring after the eighth procedure (quotient of mm X-ray/mm ERC of less than 0.3). The bending of MCGRs played a crucial role, with a higher failure rate observed on the convex side of the spinal curve (p = 0.045). Additionally, postoperative thoracic kyphosis (TK) demonstrated a potential association with distraction failure, suggesting altered spinal alignment might affect the efficacy of MCGR treatment. The study emphasizes the importance of precise MCGR bending and vigilant monitoring, especially on the convex side of the spinal curve. We discovered a notable difference between expected and real rod lengthenings, especially after multiple procedures. This emphasizes the importance of closely monitoring MCGR treatments for accurate scoliosis management in young patients. IV; retrospective study.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have