Abstract

PurposeTo evaluate SAR as a dosimetric quantity for EMF bioeffects, and identify ways for increasing the precision in EMF dosimetry and bioactivity assessment.MethodsWe discuss the interaction of man-made electromagnetic waves with biological matter and calculate the energy transferred to a single free ion within a cell. We analyze the physics and biology of SAR and evaluate the methods of its estimation. We discuss the experimentally observed non-linearity between electromagnetic exposure and biological effect.ResultsWe find that: a) The energy absorbed by living matter during exposure to environmentally accounted EMFs is normally well below the thermal level. b) All existing methods for SAR estimation, especially those based upon tissue conductivity and internal electric field, have serious deficiencies. c) The only method to estimate SAR without large error is by measuring temperature increases within biological tissue, which normally are negligible for environmental EMF intensities, and thus cannot be measured.Conclusions SAR actually refers to thermal effects, while the vast majority of the recorded biological effects from man-made non-ionizing environmental radiation are non-thermal. Even if SAR could be accurately estimated for a whole tissue, organ, or body, the biological/health effect is determined by tiny amounts of energy/power absorbed by specific biomolecules, which cannot be calculated. Moreover, it depends upon field parameters not taken into account in SAR calculation. Thus, SAR should not be used as the primary dosimetric quantity, but used only as a complementary measure, always reporting the estimating method and the corresponding error. Radiation/field intensity along with additional physical parameters (such as frequency, modulation etc) which can be directly and in any case more accurately measured on the surface of biological tissues, should constitute the primary measure for EMF exposures, in spite of similar uncertainty to predict the biological effect due to non-linearity.

Highlights

  • MethodsWe discuss the interaction of man-made electromagnetic waves with biological matter and calculate the energy transferred to a single free ion within a cell

  • Specific Absorption Rate (SAR) is defined as the amount of absorbed non-ionizing radiation power by unit mass of biological tissue.The reason for the introduction of SAR as a non-ionizing radiation – Radio Frequency (RF) Electromagnetic Field (EMF) dosimetric quantity, was – as with the rate of absorbed dose in the ionizing case – to describe the amount of absorbed energy and the rate by which it is absorbed within an exposed tissue and not just the radiation/field intensity on its surface

  • Thereby, we have shown that oscillations induced on biological molecules by environmental EMFs do not usually contribute to the tissue temperature, except if these fields were millions of times more powerful, like for example the fields within a microwave oven operating at about 1000 W and focusing all of its radiating power within its cavity, in contrast to e.g. a GSM (Global System for Mobile telecommunications) mobile phone (,0.1–1 W) or even a mobile telephony base station antenna (,10–100 W)

Read more

Summary

Methods

We discuss the interaction of man-made electromagnetic waves with biological matter and calculate the energy transferred to a single free ion within a cell. We discuss the experimentally observed non-linearity between electromagnetic exposure and biological effect

Results
Conclusions
Introduction
Discussion and Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call