Evaluation of Sensitive Analytes to Hemolysis Interference on an Automated Chemistry Analyzer.

Abstract

Hemolysis is a common reason for specimen rejection in the laboratory. Our experience suggested that hemolysis (H) flag limits are too strict for some analytes leading to unnecessary specimen rejections. This study summarizes H flags for commonly rejected analytes on the Beckman Coulter DxC 700 AU analyzer. We evaluated analytes with low-limit H flags and high rejection rates. These included: aspartate aminotransferase (AST), alanine aminotransferase (ALT), iron (IRN), potassium (K), direct bilirubin (DBIL), magnesium (Mg), amylase (AMY), sodium (Na), gamma-glutamyltransferase (GGT), phosphorus (PHOS), albumin (ALB), alkaline phosphatase (ALKP), and lactate dehydrogenase (LDH). Five patient plasma pools without hemolysis were made from 50 patient specimens. Neat pools were analyzed to establish baseline analyte concentrations. A hemolysate was created by diluting whole blood with distilled water. Each analyte was tested after spiking each pool with the hemolysate to specific hemoglobin concentrations corresponding to manufacturer's H flags. Percent differences were calculated between baseline pool means and each flag's pool mean. Acceptance limits were based upon the average of the 2019 CLIA and the method precision limits. Calculated percent differences greater than the acceptance limits were considered significant. Manufacturer-defined hemolysis flags can be updated to greater than 1+ for Na, K, and AST, greater than 3+ for ALKP, and greater than 4+ for AMY and Mg. No changes were noted for the remaining analytes. The hemolysis criteria set for ALKP, AMY, AST, Mg, K, and Na were updated in the Remisol Advance middleware, which led to a 56% reduction in rejected hemolyzed specimens.