Evaluation of fracture resistance behavior of Alloy 690 material upto 1000°C

Abstract

Alloy 690 is a nickel-based alloy with a nominal composition of 30% Cr and 10% Fe (wt%). It is denoted as Ni-30Cr-10Fe. This alloy is currently being investigated by various researchers for its use in nuclear industry as a possible replacement of alloy 600 steam generator tubes because of its excellent resistance to inter-granular stress corrosion cracking in water reactor environment. Alloy 690 is mainly used in vitrification melters for immobilization of high level waste in nuclear recycle plant. The temperature of water reactor environment is considerably lower compared to that of vitrification application, where temperature can reach an order of 1000 to 1100˚C. The mechanical and fracture properties of alloy 690 at the elevated temperature is important from the point of view of design and safety analysis of vitrification melter components and it is not available in literature. For this purpose, single edged notched tensile specimens have been fabricated from alloy 690 plates of 10 mm thickness. The fracture specimens have been tested in the temperature range of 25˚C to 1000˚C, which is the operating range of vitrification melters. The crack initiation toughness was obtained using modified blunting line equation in order to account for material strain hardening effect at a given temperature. From the fracture test results, it was observed that the initiation toughness is lowest at 700˚C. To understand this behavior, scanning electron microscopy was carried out on the fracture surface of the tested specimens. The fracture surface of the specimen tested at 700˚C showed presence of brittle phases in the microstructure, which are responsible for lower value of fracture toughness at this condition. The results of this work shall be useful for design and analysis of vitrification melter components.