Evaluation of air impingement for dry-cleaning nonfat dry milk residues on a stainless-steel surface.

Abstract

The use of air jet impingement to remove residues from surfaces in food manufacturing operations offers an alternative to the use of water and liquid cleaning agents. During this investigation, air impingement was used to remove nonfat dry milk (NFDM) residues from a stainless-steel surface. The influence of the water activity (aw ) of the residue, the time after the residue reached an equilibrium water activity, and the thickness of residue at the time of removal from the surface have been investigated. All three factors had a significant effect on the time for removal. An increase in the water activity, the time at equilibrium, the sample thickness, or a combination of all three resulted in an increase in the time required to remove the deposits. Visible changes in the structure of deposits were observed as NFDM samples equilibrated to water activities above 0.43. NFDM residues with water activities less than 0.33 were removed within 1s of using air impingement regardless of wall shear stress. When the water activities were greater than 0.50, the thickness of deposit was greater than 1mm, and the time after reaching an equilibrium water activity was over 7days, more than 5min of air impingement with wall shear stress over 9.48Pa was required to remove the residue. The results from these experiments indicated that air impingement has the potential to provide effective cleaning in manufacturing facilities for low-moisture foods. PRACTICAL APPLICATION: The introduction of water in low-moisture food environments is often undesirable due to the possibility of pathogenic microorganism growth. The normal cleaning operations in the food industry use water as a cleaning agent. This study evaluates the application of air impingement technology as a dry-cleaning method.