Abstract

Wave buoys are important devices to monitor and analyze wave data for ocean and coastal engineering. A GNSS wave buoy is briefly introduced in the paper, which has high resolution to measure the buoy motion by vertical, north-south and west-east displacements and independent velocities in above three directions. Based on the displacements and velocities, statistical results, frequency spectra and directional spectra are analyzed, and results based on the displacements are compared with that from Waverider with a distance less than 6m deployed in the special sea water with the GNSS buoy. Wave profiles comparison show that GNSS buoy presented slightly large significant wave height and mean wave height due to its high sampling frequency, and resulted in smaller mean wave period than that from Waverider. Statisticaly, between the analyzing result of the GNSS and wave rider, the maximum error of wave height is about 5.5%; and the maximum difference of wave period is about 0.5s, when sampling frequency is similar. The energy spectra were basically consistent from these two devices. The peaks of directional spectra were similar but the spreading angle was smaller from GNSS. Results mean the GNSS device presents almost similar wave information to that from Waverider.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.