Abstract
Two welding methods of FCAW (Flux-cored arc welding) + FCAW, and FCAW + GTAW (Gas tungsten arc welding) were compared to identify effective routes for STS 316L/A516-70N clad stainless steel. Since the welding speed of the FCAW + GTAW welding method is slower than that of the FCAW + FCAW welding method, the amount of heat input is large, the size of the heat-affected zone formed is larger, and the amount of angular deformation is also large. The microstructure and deformation of the welding specimens were investigated by computational simulation, and the results were compared with calculated results for actual specimens. The results were very similar, thus confirming the high accuracy of the calculation. After measuring the hardness value of the actual welded specimens, the specimen welded by the FCAW + FCAW welding method was found to have a higher hardness value. The hardness of the welded portion of the FCAW + GTAW specimen tests tended to remain at nearly the same value throughout the specimen, indicating that the FCAW + GTAW hardness profile is desirable. In the computer simulation, butt welding was used to set the optimal heat source conditions for the two welding methods, and the effect of heat formed during welding was confirmed using the thermal analysis results according to the conditions. Based on the butt welding conditions, the residual stress and strain for the two welding methods are discussed, using calculations for the welding of C-seam (circumferential seam) and L-seam (longitudinal seam) used in the manufacture of pressure vessels.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.