Abstract
This paper examines the performance of a 3D printed acoustic metamaterial as an acoustic treatment for aircraft engine nacelles in the Advanced Noise Control Fan. As the level of air travel continues to increase, so too does the demand for better noise-reduction technologies for aircraft. Engines are one of the two main sources of noise generated by aircraft, with fan noise, in particular, being of concern due to its broadband and tonal contributions. Small and lightweight methods of addressing both broadband and tonal noise are necessary due to the limitations presented by the current engine design. Presented in this paper is a novel acoustic metamaterial that has undergone design optimization for broadband noise reduction. The final design was produced using 3D printing and tested using the Advanced Noise Control Fan at the University of Notre Dame. It was found that the material is capable of reducing the first harmonic of the blade passing frequency by up to 18.5 dB, with an overall noise reduction of 3.7 dB.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
