Abstract
ABSTRACTA new method for analysing observed aeolian sand transport rate profiles of the kind obtained by Williams is presented. The method involves a mathematical model of aeolian saltation. Detailed information about the saltation process can be calculated from the transport rate profile by means of this model. The method is used to perform a re‐analysis of Williams' trap data. Among the main findings of this analysis is that the grain borne shear stress appears to be a smaller fraction of the total shear stress than assumed by Bagnold & Owen in their theories of aeolian saltation. Other findings are that the probability distribution of the jump height of the grains does not depend much on the wind speed once the saltation is established, and that the vertical component of the mean launch velocity decreases with the grain size. It is approximately inversely proportional to the grain diameter. Our estimates of the landing angles indicate that estimates of the impact angles obtained from photographically recorded trajectories are too small due to biased sampling. The influence of grain shape on the transport characteristics is mainly due to changes in the grains' ability to jump when hitting the bed. It is found that angular grains have a lower mean jump height than spherical grains.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.