Abstract

This study described a new methylene blue test to measure the methylene blue value (MBV) for 15 cohesive soils and established the relationship between MBV and plasticity index (PI) and between MBV and percent passing No. 200 sieve (P200), respectively. Thereafter, the soil‐water characteristic curves (SWCCs) for 15 cohesive soils based on Fredlund and Xing’s model were generated by the pressure plate test. Then, regression equations for determining the four fitting parameters in a previously developed SWCC equation by using the measured MBV were utilized to generate the SWCC for the cohesive soils. At the same time, the slope parameter, bf, in the SWCC equations was found to be associated with the moisture susceptibility of cohesive soils. A higher bf value indicates that the material is more moisture susceptible. In addition, a lower MBV/PI/P200 shows a lower suction at the same degree of saturation; on the other hand, a higher MBV/PI/P200 presents a higher suction. Therefore, the moisture‐holding capacity of cohesive soils increases with increasing MBV, PI, and P200. Finally, the proposed estimation method was validated by a comparison between the four determined fitting parameters from MBV and the pressure plate test.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.