Estimation of above-ground forest biomass using metrics based on Gaussian decomposition of waveform lidar data

Abstract

Large-footprint waveform light detection and ranging (lidar) data have been widely used in above-ground forest biomass estimation. Waveform metrics derived from basic statistics (e.g. percentile of energy) of the lidar waveform, such as canopy height and height of median energy, have been applied to biomass estimation in numerous studies. In this study, a set of metrics based on Gaussian decomposition (GD) results were developed and evaluated for forest above-ground biomass estimation using NASA’s laser vegetation imaging sensor (LVIS) data. The GD metrics were designed to explicitly incorporate lidar intensity and vertical structures of canopy layers for biomass estimation. The proposed GD metrics used information related to the above-ground height of each Gaussian centroid and the Gaussian area index (GAI), where GAI is the area covered by a Gaussian function. Two types of novel GD metrics were developed: (1) percentile-height GAI metrics expressing the GAI summation of a subset of Gaussian centroids located within a certain percentile height range; and (2) height-weighted GAI metrics, a summation of GAIs of a waveform weighted by the corresponding heights of their Gaussian centroids. A biomass regression model was built by eight newly developed GD metrics using GAI information and five pre-existing GD-derived metrics that have not previously been used for biomass estimation. The performance of the regression model was then compared to another regression model using 12 previously published metrics (non-GD metrics). The Random Forests (RF) regression algorithm was employed for predicting biomass. The RF out-of-bag results indicated that above-ground biomass estimations using GD metrics achieved significantly better results than those derived from non-GD metrics for deciduous plots (19% lower root mean square error (RMSE), 25% higher coefficient of determination (R2), and marginally better results in coniferous plots (4% lower RSME, 6% higher R2). The combination of GD and non-GD metrics achieved comparable biomass estimation results to the model using exclusively GD metrics. GD metrics also showed strong correlation with forest attributes such as mean diameter at breast height (DBH) and stem density. This study contributes to the usage of GD results for accurate estimation of forest above-ground biomass in large-footprint lidar waveform data in temperate deciduous forests, because temperate deciduous forests have been proved challenging in regard to lidar-derived biomass estimations.