Abstract

Snow water equivalent (SWE) measurements are necessary for the management of water supply and flood control systems in seasonal snow-covered regions. SWE measurements quantify the amount of water stored in snowpack; it can be estimated by the product of snow depth and density. In this paper, snow depth and density are estimated by a nonlinear least squares fitting algorithm. The inputs to this algorithm are global positioning system (GPS) signals and a simple GPS interferometric reflectometry model (GPS-IR) that incorporates a slightly tilted surface (GPS-IRT). The elevation angles of interest at the GPS receiving antenna are between 5° and 30°. A 1-day experiment with a snow-covered prairie grass field using GPS satellites PRN 15 and PRN 18 shows potential for inferring snow water equivalent using GPS-IRT. For this case study, the average inferred snow depth (12.4 cm) from the two satellite tracks underestimates the in situ measurements (17.6 cm ± 1.5 cm). However, the average inferred snow density (0.085 g∙cm-3) from the two satellite tracks is within the in situ measurement range (0.08 g∙cm-3 ± 0.02 g∙cm-3). Consequently, the average inferred SWE (1.05 g∙cm-2) from the two satellite tracks is within the in situ calculation range (1.40 g∙cm-2 ± 0.36 g∙cm-2). These results are also compared with the GPS-IR model.

Highlights

  • The amount of water stored in snowpack is one of the most important measurements for the management of water supply and flood control systems in seasonal snowcovered regions

  • For each global positioning system (GPS) satellite, 112 different paired combinations of snow depth and density provided the necessary resolution and range to estimate the absolute minimum between theory and measurement using a quasi-Newton algorithm (QNA)

  • Where y is the relative measured power value in dB; PdB is the normalized fitting function in dB; θi are the elevation angles in degrees; θt, t1, t2, t3, ρd, ε2, ε3, T, and f are the parameters given in Section 2; n is the number of data points for each satellite track, and min is the abbreviation for minimize

Read more

Summary

Introduction

The amount of water stored in snowpack is one of the most important measurements for the management of water supply and flood control systems in seasonal snowcovered regions. In situ snow depth and density measurements are compared with the inferred GPS-IRT and GPS-IR results. A 1-day experiment attempts to partially answer the following question: Can this simple model be used to estimate snow depth and density for a slightly tilted snow-covered prairie grass field?

Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.