Abstract
We present a methodology for generating pre-drill estimations of hydrate saturations using conventional 3D seismic data. These seismic-based estimates will be compared with well log derived saturations from the subsequently drilled wells of the Gulf of Mexico Gas Hydrate Joint Industry Project Leg II (JIP Leg II) expedition.Predicting saturation of gas hydrates (Sh-seismic) combines pre-stack seismic inversion, rock physics modeling and stratigraphic interpretation. Before the wells were drilled, no nearby sonic and density logs were available to define and calibrate the elastic property trends for the shallow target interval containing the gas hydrate stability zone. Therefore, rock property trends were established by applying principles of rock physics and shallow sediment compaction, constrained by known regional geological parameters. Sh-seismic volumes were generated by inverting pre-stack data to acoustic impedance (PI) and shear impedance (SI) volumes, and then analyzing deviations from modeled impedance trends. To enhance the quality of the inversion, the signal-to-noise ratio of the offset data was maximized by conditioning the seismic prior to inversion. Seismic stratigraphic interpretation plays an important role by identifying the more promising strata and structures for the presence of gas hydrates.The pre-drill Sh-seismic results are compared with saturations calculated from log data, Sh-log, of the wells drilled in the JIP Leg II campaign. Due to weaker seismic reflections, predictions may be less accurate for low concentrations, such as saturations less than 40%, and for thin intervals below the vertical resolution of the seismic data (about 15m). However, the integrated geophysical workflow is very effective for identifying and quantifying significant hydrate concentrations, making the method a promising prospecting technique.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call