Estimating Grain Stress and Distinguishing Between Mobility and Transportability Improves Bedload Transport Estimates in Coarse‐Bedded Mountain Rivers

Abstract

AbstractEstimating sediment transport in mountain rivers is challenging because of sediment supply limitation, broad grain size distributions, complex flow hydraulics, and large form drag. Consequently, sediment transport equations are lacking for application in rivers where the bed is coarse and largely immobile, but small fractions of finer, transportable sized material contribute disproportionately to bedload transport. We introduce a framework for estimating sediment transport in mountain rivers that addresses two limitations: estimating the shear stress acting on mobile grains, and accounting for the difference between mobility of size fractions, that is, whether or not a specific grain size can move at a given flow, and transportability, which we define as how much of that size present in the bed will be recruited into transport. We use two bedload data sets to develop equations for predicting incipient motion and transport rates of each grain size fraction present in the bed. We tested the new equations against incipient motion and sediment transport data we collected from streams in the Rocky Mountains, USA, and against published regional sediment yield data. Using this method results in transport estimates where the finer fractions, despite being a small fraction of the bed surface, make up a large part of the total yield. Fractions greater than the median bed grain size are mobile only during peak flood flows, consistent with the existing mountain river bedload data sets. The approach is parsimonious, requiring only data that are often readily available or obtainable: a bed grain size distribution, hydraulic geometry measurements, and discharge.