Estimating forest biomass and identifying low-intensity logging areas using airborne scanning lidar in Antimary State Forest, Acre State, Western Brazilian Amazon

Abstract

Listen

Translate article

The objectives of this study were to estimate above ground forest biomass and identify areas disturbed by selective logging in a 1000ha Brazilian tropical forest in the Antimary State Forest (FEA) using airborne lidar data. The study area consisted of three management units, two of which were unlogged, while the third unit was selectively logged at a low intensity (approximately 10–15m3 ha−1 or 5–8% of total volume). A systematic random sample of fifty 0.25-ha ground plots were measured and used to construct lidar-based regression models for above ground biomass (AGB). A lidar model-assisted approach was used to estimate AGB for the logged and unlogged units (using both synthetic and model-assisted estimators). Two lidar explanatory variables, computed at a spatial resolution of 50m×50m, were used in these predictions: 1) the first quartile height of all above ground returns (P25); and, 2) variance of the height above ground of all returns (VAR). The model-assisted AGB estimator (total 231,589Mg±5,477 SE; mean 231.6Mg ha−1±5.5 SE; ±2.4%) was more precise than plot-only simple random sample estimator (total 230,872Mg±10,477 SE; mean 230.9Mg ha−1±10.5 SE; ±4.5%). The total and mean AGB estimates obtained using the synthetic estimator (total 231,694Mg; mean 231.7Mg ha−1) were nearly equal those obtained using the model-assisted estimator. In a second component of the analysis lidar metrics were also computed at 1m×1m resolution to identify areas impacted by logging activities within the selectively harvested management unit. A high-resolution canopy relative density model (RDM) was used in GIS to identify and delineate roads, skidtrails, landings and harvested tree gaps. The area impacted by selective logging determined from the RDM was 58.4ha or 15.4% of the total management unit. Using these two spatial resolutions of lidar analyses it was possible to identify differences in AGB in selectively logged areas that had relatively high levels of residual overstory canopy cover. The mean AGB obtained from the synthetic estimator was significantly lower in impacted areas than in undisturbed areas of the selectively logged management unit (p=0.01).