Estimates of net primary productivity and actual evapotranspiration over the Tibetan Plateau from the Community Land Model version 4.5 with four atmospheric forcing datasets

Abstract

Abstract The accuracy of simulation of carbon and water processes largely relies on the selection of atmospheric forcing datasets when driving land surface models (LSM). Particularly in high-altitude regions, choosing appropriate atmospheric forcing datasets can effectively reduce uncertainties in the LSM simulations. Therefore, this study conducted four offline LSM simulations over the Tibetan Plateau (TP) using the Community Land Model version 4.5 (CLM4.5) driven by four state-of-the-art atmospheric forcing datasets. The performances of CRUNCEP (CLM4.5 model default) and three other reanalysis-based atmospheric forcing datasets (i.e., ITPCAS, GSWP3, and WFDEI) in simulating the net primary productivity (NPP) and actual evapotranspiration (ET) were evaluated based on in-situ and gridded reference datasets. Compared with in-situ observations, simulated results exhibited determination coefficients (R2) ranging from 0.58–0.84 and 0.59–0.87 for observed NPP and ET, respectively, among which GSWP3 and ITPCAS showed superior performance. At the plateau level, CRUNCEP-based simulations displayed the largest bias compared to the reference NPP and ET. GSWP3-based simulations demonstrated the best performance when comprehensively considering both the magnitudes and change trends of TP-averaged NPP and ET. The simulated ET increase over the TP during 1982–2010 based on ITPCAS was significantly greater than in the other three simulations and reference ET, suggesting that ITPCAS may not be appropriate for studying long-term ET changes over the TP. These results suggest that GSWP3 is recommended for driving CLM4.5 in conducting long-term carbon and water processes simulations over the TP. This study contributes to enhancing the accuracy of LSM in water-carbon simulations over alpine regions.