Abstract
Degradation of surfaces of hydroturbine components caused by impact of abrasive particles carried by flowing water is a serious issue. To counteract the same, surface modification of turbine materials by the application of protective coatings is gaining popularity these days. In this work, Cr3C2–NiCr coating was deposited on CA6NM turbine steel by the HVOF spray process and studied with regard to its performance under different slurry erosion conditions. The effect of three parameters, namely average particle size of slurry particles, speed (rpm), and slurry concentration on slurry erosion of this coating material, was studied by using a high speed erosion test rig. The analysis of the surfaces of the samples before and after slurry erosion tests was done by using SEM. The HVOF sprayed Cr3C2–NiCr coating showed very good performance under slurry erosion in comparison with uncoated CA6NM steel.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.