Environmental pollution impact on water and sediments of Kumaun lakes, Lesser Himalaya, India: a comparative study

Abstract

A study of the water and sediment chemistry of the Nainital, Bhimtal, Naukuchiyatal and Sattal Lakes of Kumaun, has shown that the water of these lakes are alkaline and that electrical conductivity, total dissolved solid and bicarbonate HCO 3 − are much higher in Nainital than in the other three lakes. The weathering of limestone lithology and anthropogenic pollution, the latter due to the very high density of population in the Nainital valley, are the primary sources of enhanced parameters. The low pH of Nainital Lake water is due to low photosynthesis and enhanced respiration, increasing CO2 in the water and the consequent enhancement of Ca2+ and HCO 3 − . The dissolved oxygen in Nainital Lake is less compared to other lakes, indicating anoxic conditions developing at the mud–water interface at depth. The PO 4 3− content in Nainital is higher (124 μg/l), showing an increasing trend over time leading to eutrophic conditions. The trace metals (Cu, Co, Zn, Ni, Mn, and Sr) are present in greater amounts in the water of Nainital Lake than in the other three lakes, though Fe and Cr are high in Bhimtal and Fe in Naukuchiyatal. The higher abundance is derived from the leaching of Fe–Mg from metavolcanic and metabasic rocks. Most of the heavy metals (Cr, Ni, Cu, Mn, Fe, Sr, and Zn) significantly enrich the suspended sediments of the lakes compared to the bed sediments which due to their adsorption on finer particles and owing to multiple hydroxide coating and organic content, except for Fe, which is enriched in the bed sediments. The high rate of sedimentation, 11.5 mm/year in Nainital, compared to Bhimtal with 4.70 mm/year, Naukuchiyatal with 3.72 mm/year, and Sattal with 2.99 mm/year, has resulted in shorter residence time, poor sorting of grains, and lesser adsorption of heavy metals, leading consequently, their depletion in the bed sediments of Nainital Lake.