Environmental life cycle assessment (LCA) as a tool for identification and assessment of environmental aspects in environmental management systems (EMS)

Abstract

The paper presents a discussion on the possibilities of using LCA in identification and assessment of environmental aspects in environmental management systems based on the requirements of the international ISO14001 standard and the European Union EMAS regulation. Some modifications of LCA methodology are proposed in Part 1 while the results of a review of environmental aspects for 36 organisations with implemented EMS are presented in Part 2 of the article. The scope of the systems analysed in EMS and in LCA is different. This comes as the result of the fact that both ISO 14001 and EMAS are focused on an organisation on contrary to ISO14040x which are focused on a product life cycle. For the present work, this resulted in a need of adjusting the LCA methodology to EMS specificity and vice versa. Some suggestions of such modifications are presented and discussed in the paper. A preliminary analysis was carried out on 36 organisations which have environmental management systems compliant with the ISO14001 or EMAS regulations. A certain disproportion between input and output related environmental aspects included in most of the analysed registers was found. The probable reasons for such disproportion could be the fact that the output related environmental aspects are easier to manage by organisation and are often regulated by laws. Legal requirements are a significant criterion in the environmental aspects assessment. Based on the assessments carried out and the observations made, some conclusions have been drawn with regard to weaknesses and strengths and usefulness of LCA, as a result of a comparison to the traditional approaches used in EMS in the discussed area. LCA has evident advantages like: standardised methodology, possibility of inclusion of the quantitative information, presence of some methodological steps enabling the verification of the collected data, and ability to generate of reproducible results. At the same time, the following potential weak points can be observed: a complexity of the procedure, higher time, and cost requirements (especially related to an inventory phase); difficulties with assessing of environmental aspects with the qualitative character and these related to emergency situations; and limitation related to the lack of relevant characterisation factors in the currently used life cycle impact assessment methods. LCA ought to be considered as a tool used for identification and assessment of environmental aspects in environmental management systems. The listed limitations do not disqualify its suitability to be used. After certain simplifications, LCA seems to be a valuable alternative to the methodologies currently in use.