Enhancing microstructural integrity and mechanical performance of thick wire-arc directed energy deposited eutectic aluminum-silicon solid structure through continuous multi-pass friction stir processing

Abstract

In wire-arc directed energy deposition (waDED), fabricating larger 3D components with single-layer tracks is challenging due to limitations in track thickness, requiring the development of bead overlapping strategies. However, fusion-based 3D-printed aluminum structures often show porosity and coarse-grained microstructures, limiting their industrial applications. To address these limitations, this study employs continuous multi-pass friction stir processing (FSP) on a waDED-produced aluminum block (140 mm × 150 mm × 28 mm). The severe plastic deformation induced by FSP triggers dynamic recrystallization (DRX), promoting the formation of equiaxed grains with an average grain size 8.75 times smaller than the as-fabricated waDED sample (67.03 μm vs 7.66 μm). Transmission Electron Microscopy (TEM) revealed decreased dislocation loops post-FSP, indicating DRX and dislocation annihilation. X-ray micro-computed tomography (X-CT) examination showed complete elimination of porosity in the waDED sample, owing to the intense mechanical stirring induced during FSP. Scanning electron microscopy (SEM) images of the waDED samples showed fibrous eutectic networks disrupted by FSP, leading to a uniform distribution of broken Si particles within the α-Al matrix. Hardness decreased by approximately 38 % (86 HV0.1 vs 53 HV0.1), while the average ultimate tensile strength decreased by about 4 % in the FSP-treated samples (159.19 MPa vs 153.02 MPa). Additionally, the formation of alpha fiber and weak cube texture components during FSP enhances ductility, as evidenced by a sixfold improvement in elongation (1.93 % vs 11.59 %). This textural transformation contributes to the characteristic deeper and more uniform dimples in the FSP-treated samples, indicative of ductile fracture, compared to the premature failure patterns in as-deposited samples.