Enhancing Mechanical Performance of High-Lignin-Filled Polypropylene via Reactive Extrusion.

Abstract

Polypropylene (PP) is one of the most extensively used commodity plastics. In terms of eco-friendliness, it is worth considering preparing high-lignin-filled PP. This study explores the incorporation of high lignin content, derived from acetic acid lignin (AAL) and Kraft lignin (KL), into PP through twin-screw extrusion and injection molding. The challenge lies in maintaining mechanical performance. A compatibilizer-specifically, maleic anhydride-grafted polypropylene (MAPP)-is employed to enhance lignin-PP compatibility by chemically bonding with lignin and physically associating with the PP phase. Results indicate that KL maintains better dispersity than AAL. Compatibilizers with a high maleic anhydride (MA) level (≥0.8 wt.%) and moderate melt flow index (MFI) in the range of 60-100 g 10 min⁻¹ prove favorable in constructing a reinforced PP/KL network. Optimizing with 40 wt.% lignin content and 10 parts per hundred (pph) of compatibilizer yields blends with mechanical performance comparable to neat PP, exhibiting a notable increase in modulus and heat deflection temperature (HDT). Furthermore, utilizing PP/lignin blends can lead to a 20% reduction in expenses and approximately 40% reduction in PP-induced greenhouse gas (GHG) emissions. This approach not only reduces PP costs but also adds value to lignin utilization in a sustainable and cost-effective manner.