Enhancing machinability in free-cutting duplex brass alloys: Isotropic blocky α phase formation via optimized hot extrusion processing

Abstract

Listen

Translate article

Despite the active utilization of duplex brass alloys in the electronics and automotive industries, optimizing thermomechanical treatment conditions for achieving excellent machinability remains a subject of ongoing debate. In this study, to establish a strategy to achieve enhanced machinability via industrial-scale direct hot extrusion processing, we systematically investigated the effect of hot extrusion processing conditions on microstructural evolution, mechanical properties, and machinability of duplex brass alloys. In particular, the yield strength was effectively interpreted through the extended Hall-Petch relationship, and the machinability was further elucidated through the evaluation of rotational torque during the drilling test as well as the precise analysis of segmented chips produced in the drilling test. As a result, our microstructural analysis of the as-cast Cu58Zn39Pb3 alloy revealed that the cooling process during industrial-scale casting inevitably results in the formation of the Widmanstätten structured α phase and the heterogeneous dispersion of Pb particles. In contrast, 670 ℃ extruded lower part and 730 ℃ extrudates, which were extruded in the single β region that caused complete dynamic recrystallization behavior, exhibited a uniform and isotropic blocky α structure and uniformly redistributed Pb particles, ultimately leading to superior mechanical properties and machinability. Notably, our findings suggest that achieving an isotropic blocky α structure can be attained at temperatures up to 100 ℃ below the β-transus temperature by optimizing extrusion pressure conditions. This approach offers an efficient methodology for minimizing defects caused by high-temperature extrusion, such as surface oxidation and hot shortness cracking, while simultaneously minimizing processing costs.