Enhancement of the light output efficiency and thermal stability of AlGaN-based deep-ultraviolet light-emitting diodes with Ag-nanodot-based p-contacts and an 8-nm p-GaN cap layer.

Abstract

Listen

Translate article

The efficiency of AlGaN-based deep-ultraviolet light-emitting diodes (DUV LEDs) is limited by the high absorption issue of the p-GaN contact layer or poor contact properties of the transparent p-AlGaN contact layer. Enhancement of the light output efficiency and thermal stability of DUV LEDs with an emission wavelength of 272 nm was investigated in this work. Ag nanodots on an 8-nm p-GaN cap layer were used to form ohmic contact, and Al and Mg reflective mirrors were employed to enhance the light output power (LOP) of DUV LEDs. However, serious deterioration of LOP occurred after the high-temperature process for the LEDs with Al and Mg reflective mirrors, which can be attributed to the damage to the ohmic contact properties. A Ti barrier layer was inserted between the Ag/p-GaN and Al layers to prevent the degeneration of ohmic contact. The wall-plug efficiency (WPE) of DUV LEDs fabricated by the Ag-nanodot/Ti/Al electrode is 1.38 times that of LEDs fabricated by adopting a thick Ag layer/Ti/Al at 10 mA after a high-temperature process. The Ag-nanodot/Ti/Al electrode on thin p-GaN is a reliable technology to improve the WPE of DUV LEDs. The experimental and simulated results show that the ohmic contact is important for the hole-injection efficiency of the DUV LEDs when p-GaN is thin, and a slight increase in the contact barrier height will decrease the WPE drastically. The results highlighted the importance of thermally stable ohmic contacts to achieve high-efficiency DUV LEDs and demonstrated a feasible route for improving the LOP of DUV LEDs with a thin p-GaN cap layer and stable reflective electrodes.