Abstract

Wind turbines are of the most promising devices to cut down carbon emissions. However, some phenomena that adversely affect their performance are inevitable. The aim of the present paper is to investigate flow separation prevention exploiting leading edge (LE) single dielectric barrier discharge plasma actuator (SDBD-PA) on an airfoil belonging to a section of a locally developed wind turbine. The numerical results of the surface pressure distribution over the airfoil were compared with the experimental measurements carried out by the authors on the same blade section, and good agreement was found between numerical and experimental data for both plasma-OFF and plasma-ON cases. An in-depth parametric numerical investigation was then carried out to provide a better understanding of the flow behavior affected by the activation of PA over the same airfoil at post stall angle of attacks (AOAs). According to the results, the frequency and voltage of actuation, AOA, and free stream velocity are shown to have strong impacts on separation delay and actuation effectiveness. In Reynolds number of 2.85 × 105, the maximum PA effectiveness takes place at 21° which is approximately 312%, 307%, and 256% corresponding to the PA location of LE, 0.02 chord, and 0.15 chord, respectively. Also, maximum velocity of the domain is increased three times of the free stream velocity on average for three investigated Reynolds numbers at the frequency and voltage of 12 kHz and 12 kV, respectively. Furthermore, the size of the wake area noticeably contracts due to the presence of the SDBD-PA. The results clearly indicate that the lift and drag coefficients as well as the lift-to-drag ratio fit a linear variation pattern with the frequency of actuation. The variation rate of the aforementioned parameters becomes steeper as the peak voltage of actuation increases. Highly nonlinear aerodynamic responses and significant interactions were demonstrated between the investigated parameters.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call