Enhanced tribological performance of MoS2 and hBN-based composite friction materials: Design of tribo-pair for automotive brake pad-disc systems

Abstract

This research comprehensively analyzes the friction and wear behavior of composite friction materials when dry sliding against grey cast iron and laser-clad nickel-based (LC1) and iron-based (LC2) alloy discs. The composite friction materials (P1, P2, P3, P4, P5, and P6) under investigation contain graphite, MoS2, and hBN-based solid lubricant synthesized through the powder metallurgy technique. Tribological tests were conducted using a pin-on-disc configuration to simulate the dynamic interaction between the composite materials and the laser-clad grey cast iron discs. The tests were performed at a 60 N load, 6283.19 m sliding distance, and 2.094 m/s sliding velocity under dry sliding conditions. The results provide valuable insights into the effectiveness of MoS2 and hBN-based solid lubricant composites in reducing friction and wear when in contact with iron and nickel alloy-based laser-clad grey cast iron surfaces. The study elucidates the mechanisms governing tribological behavior, including the formation of friction plateaus and the role of laser-clad counter-discs in reducing wear. The specific wear rate of the nickel-based laser-clad counter disc (LC1) and iron-based laser-clad (LC2) system improved by 63.76 % and 48.32 %, respectively, compared to the conventional grey cast iron disc system when using the hBN-based pin (P6). Additionally, the specific wear rate of the hBN-based pin was 38.49 % lower than the conventional graphite-based pin when sliding against the grey cast iron counter-disc. Artificial Neural Network (ANN) was used to validate the wear rate of the best-performing tribological pair, namely the hBN-based pin (P6) and LC2 counter discs, through supervised learning.