Enhanced performance of HTM-free perovskite solar cells with free-standing carbon electrode via surface treatment and conductive support

Abstract

This study explores the optimization of hole transport material (HTM)-free perovskite solar cells featuring laminated free-standing carbon film as a back electrode. Surface treatment of perovskite film using different types of solvent (chlorobenzene, toluene, and ethyl acetate) was carried out to improve the electrical contact at the carbon/methylammonium lead iodide interface. Overall, the surface treatment improved mechanical adhesion between the perovskite and carbon film. The conductivity of the free-standing carbon electrode was further improved by attaching the carbon film to various types of conductive support. Our results show that the selection of both solvents used during surface treatment and the type of conductive substrate has a considerable impact on the resulting performance, wherein all modifications gave rise to substantial improvement over the benchmark unmodified carbon electrode. A power conversion efficiency (PCE) of 7.74% was achieved by the perovskite solar cell with laminated carbon electrode on Al foil combined with the application of chlorobenzene as surface treatment, demonstrating a tremendous increase in performance compared to that of untreated free-standing carbon electrode that produced PCE less than 1%. The main contributor to the improved performance is presumably due to the low carrier recombination rate and improved charge carrier extraction as implied by the electro-impedance spectroscopy and photoluminescence analysis. This work demonstrates a facile approach for resolving the challenges in developing low-cost HTM-free perovskite solar cells with a free-standing carbon film electrode.