Abstract

In the present work, pure and magnesium doped Cu2O films were deposited on glass substrates by nebulizer spray pyrolysis method with doping concentrations of 0, 3, 5 and 7% at 280 °C. The as-prepared films were analyzed by XRD, AFM, laser Raman, UV–Vis, photoluminescence, Hall Effect measurements. An X-ray diffraction study clearly depicts that films are possessing polycrystalline nature with a cubic structure. The surface topological properties have been characterized using atomic force microscopy (AFM) which reveals nano shaped hill rock grains covered the surface of the substrate. Laser Raman spectroscopy studies confirm the peaks observed at 109, 148, 217, 416 and 514 cm−1 belong to Cu2O phase. UV–Vis spectrophotometer measurements show that the band gap is decreased from 2.25 to 1.9 eV for the increase of doping concentration Mg. Photoluminescence spectral analysis giving an emission peak at 630 nm confirmed the formation of cuprous oxide. The electrical studies showed that the films are of p-type. For the doping of 7% Mg concentration the Cu2O showed a resistivity 1.53 × 102 andhigh carrier concentration of 21.67 × 1016 cm−3. FTO/ZnO/Cu2O/Ag heterojunction was fabricated using 7% Mg doped Cu2O thin film, and found the open circuit voltage (Voc) as 0.25 V, short circuit current (Isc) as 0.225 × 10−4 A and the efficiency as 0.65% for the 7% Mg doped Cu2O thin film.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.