Abstract
AbstractWe evaluate the feasibility of electrospinning oil‐in‐water type emulsions. The emulsions had an aqueous solution of polyethylene oxide (PEO) as the continuous phase, and either mineral oil or a polystyrene (PS) in toluene solution as the drop phase. The Taylor cones and electrified liquid jets were stable even when the emulsion drops were as large as a few‐ten microns in diameter. The resulting electrospun PEO fibers incorporated the dispersed phase of the emulsion in the form of drops (in case of mineral oil), or in the form of solid particles (in case of PS). Mineral oil drops appear to be completely encapsulated in the PEO fibers, whereas the PS particles are either incompletely encapsulated, or covered by only a very thin layer of PEO. Calculations show that in both cases, the initially large emulsion drops are broken during the electrospinning process. Copyright © 2007 John Wiley & Sons, Ltd.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.