Abstract

As a powerful method to reduce actuation voltage in an electrostatic micro-actuator, we propose and investigate an electrostatic micro-actuator with a pre-charged series capacitor. In contrast to a conventional electrostatic actuator, the injected pre-charges into the series capacitor can freely modulate the pull-in voltage of the proposed actuator even after the completion of fabrication. The static characteristics of the proposed actuator were investigated by first developing analytical models based on a parallel-plate capacitor model. We then successfully designed and demonstrated a micro-switch with a pre-charged series capacitor. The pull-in voltage of the fabricated micro-switch was reduced from 65.4 to 0.6 V when pre-charged with 46.3 V. The on-resistance of the fabricated micro-switch was almost the same as the initial one, even when the device was pre-charged, which was demonstrated for the first time. All results from the analytical models, finite element method simulations, and measurements were in good agreement with deviations of less than 10%. This work can be favorably adapted to electrostatic micro-switches which need a low actuation voltage without noticeable degradation of performance.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call