Abstract
As the use of stretchable electronic devices increases, the importance of flexible electromagnetic interference (EMI) shielding films is emerging. In this study, a highly flexible shielding film was fabricated using poly(styrene-co-butyl acrylate) (p(St-co-BA)) latex as a matrix and poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) as a conductive filler, and then the mechanical properties and EMI shielding performance of the film were examined. Styrene and butyl acrylate were copolymerized to lower the high glass transition temperature and increase the ductility of brittle polystyrene. The latex blending technique was used to produce a shielding film in which the aqueous filler dispersion was uniformly dispersed in the emulsion polymerized resin. To determine the phase change in the copolymer matrix with temperature, the storage modulus was measured, and a time-temperature superposition master curve was constructed. The drying temperature of water-based copolymer resin suitable for film fabrication was set based on this curve. The glass transition temperature and flexibility of the blends were determined by evaluating the thermomechanical analysis and tensile tests. The EMI shielding effectiveness (SE) of the films was analyzed at frequencies from 50 MHz to 1.5 GHz, covering the VHF and UHF ranges. As the filler content increased, the SE of the blend film increased, but the elongation increased until a certain content and then decreased. The optimal content of PEDOT:PSS that satisfied both the ductility and shielding performance of the film was found to be 10 wt%. In this case, the elongation at break reached 300%, and the SE of a 1.6 mm thick film was about 35 dB. The film developed in this study can be used as an EMI shielding material that requires high flexibility.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call