Abstract
Hydrogen is a carbon-free alternative energy source that is environmentally friendly, has high energy density, and is a promising fuel for future generations. Water splitting is an efficient way to produce hydrogen, requiring a catalyst with a small overpotential and Tafel slope, and good stability. However, only 4 % of global hydrogen is produced by water electrolysis due to high cost and lack of inexpensive replacements of the active platinum electrocatalyst.1 However, replacing these noble metal electrocatalysts with those comprised of lower, earth-abundant elements remains challenging as these materials impart a higher overpotential and thus require higher energy. Guided by the recognised enhancements of TiO2 particles in Co-Mo alloys for HER, earth-abundant, low-cost Ni and Fe metals are examined as composite electrocatalysts Ni-Fe-TiO2 towards HER.2 Nano-scale TiO2 particles were embedded into Ni-Fe alloys by using galvanic and pulse-reverse electrodeposition, onto rotating cylinder electrodes. Pulse-reverse electrodeposition considerably increased the concentration of the particles incorporated into the alloy. The composition and morphology were characterized by X-ray fluorescence (XRF) spectroscopy and scanning electron microscopy (SEM), respectively. The addition of particles to the electrolyte affected both the deposit composition and morphology. The alloy composites were then used as electrocatalysts in 1 M KOH to characterize HER via linear sweep voltammetry on the resulting hydroxide surface. The surface area was examined in a ferri/ferrocyanide electrolyte. The polarization data in 1 M KOH shows a significant reduction in the HER overpotential when TiO2 particles are present in the Ni-Fe deposit. The surface analysis of Ni-Fe and Ni-Fe-TiO2 confirmed that the improvement in HER activity is not due to surface roughness but an intrinsic one. The stability of the electrocatalysts under an electrolysis for HER was examined at -10 mA/cm2 for 24 hr and the working electrode potential remained stable over time; Tafel polarization curves after electrolysis were similar to those prior to electrolysis. References Le, P. A., Trung, V. D., Nguyen, P. L., Phung, T. V. B., Natsuki, J., & Natsuki, T. RSC advances, 13(40), 28262-28287 (2023).C. Wang, H. K. Bilan, and E. J. Podlaha. J. Electrochem. Soc. 166 F661 (2019). C. Wang and E. J. Podlaha, J. Electrochem. Soc. 167, 132502 (1~4) (2020).
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call