Abstract

The supercapacitors have emerged as an important energy storage device as they can deliver a high specific power, long cycle life, and much higher charge-discharge rates than a battery. In particular, solid-state supercapacitors have gained worldwide attention as an emerging candidate for smart and efficient energy storage devices due to the increasing demand for miniaturized electronics. Electric double layer capacitors (EDLCs) are the most widely studied class of supercapacitors which physically stores charge by forming an electric double layer at the interfaces between the high surface area carbon electrode and the electrolyte. The conventional EDLCs using high surface area activated carbon electrodes and non-aqueous liquid electrolytes represent the current state of the art. The most common cause of failure of such devices is related to the electrolyte leakage. Most of the past work on EDLCs have been carried out using the liquid electrolytes (aqueous, organic and pure ionic liquid). The gel polymer electrolytes with high ionic mobility and good dimensional/mechanical stability, offer a viable substitute for the liquid electrolytes and they are being used for flexible and solid-state electrochemical energy storage devices. Here, we report the electrochemical performance of high surface area activated carbon based EDLCs using 1-ethyl-3-methylimidazolium dicyanamide (EMImDCA) ionic liquid and its poly(vinylidene fluoride-co-hexafluoropropylene) (PVdF-HFP) gel counterpart as electrolytes. The gel electrolyte films were prepared by immobilizing the EMImDCA ionic liquid in PVdF-HFP copolymer matrix by solution casting method. The activated carbon electrodes were prepared by mixing the activated carbon powder with conductive additive (Super C65) and PVdF-HFP binder in a ratio of 8:1:1 (w/w/w), and then the mixture was drop-casted onto a flexible thin graphite sheet which serves as current collector. The solid-state EDLC cells were fabricated by sandwiching the gel electrolyte film between two identical activated carbon electrodes whereas EDLC cells with pure IL were fabricated by using fiberglass separator soaked with IL. The EDLC cells show highly capacitive behavior as evident from the cyclic voltammogram of the cells measured at a scan rate of 20 mV s-1 which is rectangular in shape (Fig 1a). However, gel electrolyte based solid-state cell shows slightly higher resistance, obvious from slight deviation from rectangular shape at both turning potential. Typical galvanostatic charge-discharge characteristic of the EDLC cells at current density of 5 mA cm-2is shown in Fig. 1b. The linear discharge characteristics of the cell further confirms the capacitive behavior of the cells due to formation of an electric double layer at the interfaces. The EDLC cell with pure IL shows specific capacitance of ~98 F g-1 whereas IL-gel based EDLC cell shows specific capacitance of ~86 F g-1, derived from charge-discharge curves at 5 mA cm-2. A comparative performance of the EDLC cells was carried our using the impedance spectroscopy, cyclic voltammetry, and galvanostatic charge-discharge techniques. This paper discusses the results of these comparative studies with pure IL and its PVdF-HFP gel electrolytes. Figure 1

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.